Lee 7MM REM MAG Case Length Gauge is a precise, easy way to trim to length and square the case mouth. Used with the Cutter and Lock Stud. Trim to length 2.480 to 2.500 inches.

This reloading system is a patented quick change bushing system letting you change dies with a simple flick of the wrist. With Lock-N-Load technology in your reloading press, you can stop loading, change dies and start loading another calibre in seconds.

These replacement decapping units feature an expander rod, expander ball, and decapping pin. They are used in sizing dies to de-prime the case and expand the case neck in bottleneck cartridges. It is always a good idea to keep an extra decapping unit on-hand so you can ensure your reloading sessions do not get interrupted if you ever damage them during use. Factory Replacement Part Precision Machined to ensure concentricity Expander Rod, Expander Ball and Decapping Pin .264/6.5mm Note: Not for use with 6.5 Creedmoor; for 6.5 Creedmoor use part number 9839

RCBS Single Stage shell holders are built from hardened steel and designed to properly align the case with the reloading die in single-stage and turret presses.

Our shell plates feature a subtle radius on each shell holder mouth to ensure smooth and reliable functioning. The retainer spring is designed to stay in place when inserting cases into the shell plate.

Works well with Blackhorn 209, Pyrodex® Pellets, and loose powder!

Shell plates feature a subtle radius on each shell holder mouth to ensure smooth and reliable functioning. The retainer spring is designed to stay in place when inserting cases into the shell plate.

Everything you need for quick loading in one package. This one tool does it all: carries your powder, your cap, your projectile and serves as your bullet starter. Works well with round balls, conicals or sabots.

A synthetic based lube that withstands the high operating temperatures of muzzleloaders to prevent fouling residue from binding breech plugs. Also works well on nipples and shotgun choke tubes. 1/2 oz. Tube with applicator tip.

Starts patched round balls, conical bullets and saboted bullets. Classic, hand filling round handle. Wide flanged, contoured starter tips. Hole for lanyard.

Precision machined from solid steel and heat-treated to perform flawlessly. Wide mouth and rounded edge at the opening allow smoother case insertion.

Hornady Sure-Loc Lock Rings fit on standard 7/8 -14" threaded dies and accessories. Splint ring design die lock rings applies constant pressure and wrench flats for easy on/off.

Neck Sizer Dies size only the neck of case (not the shoulder or body) just enough to snugly hold the bullet which leads to increase case life and accuracy.

Neck Sizer Dies size only the neck of case (not the shoulder or body) just enough to snugly hold the bullet which leads to increase case life and accuracy.